23948sdkhjf

ATOS ScanBox Series 8

| Medlemsnyhet | Bedrift Carl Zeiss AS

Complete measurement of entire car bodies and attached parts

With ATOS ScanBox Series 8, complete vehicles are digitized at high speed, both from the outside and the inside. The modular measuring cell has established itself among OEMs as a complete solution for analyses in Meisterbock and Cubing, the inspection of finished vehicles, and for quality assurance in car body manufacturing. Take advantage of the wide range of possibilities of ATOS ScanBox Series 8 : Virtually merge measurements of multiple parts and use the powerful GOM Inspect Pro software for linear evaluation of detailed information on gap and flush.

Automated Scanning in Double Robot Mode
Two 8-axis kinematics allow for full-field measurement of particularly large assemblies. The duplex mode ensures synchronous, coordinated use of two robots in the measuring cell. In this process, a joint data set of measurements is created, as the double robot mode takes place in a shared coordinate system. Depending on your needs, the two robots of ATOS ScanBox Series 8 can also be used for independent measurement on two different parts.

Depending on the specific requirements, ATOS ScanBox Series 8 can be extended by one or two rotation table working areas. With this upgrade, you can respond even more flexibly and quickly to production changes and increase throughput.

More information can be found here.

 

 

Medlemsnyhet

Bedrift
Carl Zeiss AS

Kabelgaten 8
0512 OSLO
Norge
Carl Zeiss AS

Send til en kollega

0.11